Online 1Z0-404 Practice Test

Question 1

After configuring Header Manipulation Rules (HMRs) for topology hiding, your subsequent testing shows that the manipulation is not takingeffect. Identify two causes for this (Choose two.)

Options :

A :

You have not configured the out-manipulationid parameter of the sip-interface configuration element.

B : You have not enabled policy-based realm-bridging

C :

The value of the name parameter in the header-rule configuration element is different than the value of the out-manipulationid parameter in the sip-interface configuration element.

D : The value of the match-val-type parameter is not written correctly

E :

The home-proxy-address value does not matchthe $LOCAL_IP value in the new-value parameter.

Answer: A,E

Question 2

A steering pool defines _____________.

Options :

A : a range of ports used to route media flows as they egress the Session Border Controller

B :

an IP address and port the Session Border Controller uses for steering media to the external media server

C :

an IP address and range of ports the Session Border Controller will use to declare itself as the destination for media flows in a session

D :

a range of IP addresses and a pool of ports the Session Border Controller will use to declare itself as the destination for all subsequent media flows in a dialog

E :

arange of IP addresses used to route media flows as they egress the Session Border Controller

Answer: C

Question 3

You wantto configure the maximum duration in seconds of any session in the Session Border Controller. How would you accomplish this?

Options :

A : Navigate to the media-manager configuration element and configure the max-signalingbandwidth parameter.

B :

Navigate to the media-manager configuration element and configure the flow-time-limit parameter

C :

Navigate to the sip-config configuration element and configure the operation-mode parameter.

D :

Navigate to the sip-config configuration element and configure theflow-time-limit parameter

E :

Navigate to the media-manager configuration element and configure the latching parameter.

Answer: C

Question 4

Which two states are needed by the active node while transitioning to standby? (Choose two.)

Options :

A : Out of service

B : Becoming-active

C : Relinquishing-standby

D : Relinquishing-active

E : Becoming-standby

Answer: B,D

Question 5

What is the first thing you should do when you want the Session Border Controller to detect that anendpoint is behind a NAT/firewall device?

Options :

A :

Navigate to the sip-port configuration element and set the nat-traversal parameter to disabled

B :

Navigate to the sip-interface configuration element and set the nat-traversal parameter to never.

C :

Navigate to the sip-interface configuration element and set the nat-traversal parameter to always

D :

Navigate to the sip-port configuration element and set the nat-traversal parameter to enabled.

E :

Navigate to the sip-interface configuration element and set the nat-traversal parameter to detect

Answer: C

EXPERTY DESIGNED 1Z0-404 PRACTICE TEST